Search Icon White
additive manufacturing

ANSI Participates in America Makes Technical Review and Exchange Discussion of Additive Manufacturing Standards

12/21/2020
ANSI News

Recording Available

The American National Standards Institute (ANSI) announced today its participation in a December 10 America Makes mini technical review and exchange (TRX) on additive manufacturing. The event featured an overview of the America Makes and ANSI Additive Manufacturing Standardization Collaborative (AMSC) and a moderated discussion of trends and activity responsive to the recommendations contained in the AMSC’s Standardization Roadmap for Additive Manufacturing (version 2.0, June 2018). America Makes has made a recording of the event available.

The AMSC was launched in 2016 as a cross-sector coordinating body whose purpose is to accelerate the development of industry-wide additive manufacturing standards and specifications consistent with stakeholder needs. Supported by industry, government, academia, and standards developing organizations (SDOs), the collaborative has produced two version of a roadmap describing the current and desired future standardization landscape for additive manufacturing. The AMSC also has created an online tracker to capture ongoing work by SDOs and research and development organizations to address the gaps identified in the roadmap. The goal is to drive coordinated standards development activity that will help to grow the additive manufacturing industry.

Participating in the December 10 event from ANSI was Jim McCabe, senior director, standards facilitation, and staff lead for the AMSC initiative. A panel discussion on process control to enable qualification included the following speakers:

  • Amber Andreaco, GE Additive
  • Bill Bihlman, Aerolytics, representing SAE International
  • Shane Collins, Additive Industries North America, Inc., representing ASTM International
  • Hallee Deutschman, Siemens Corporate Technology
  • Kathryn Hyam, American Society of Mechanical Engineers
  • Blake Marshall, U.S. Department of Energy

Brandon Ribic, Ph.D., technology director at America Makes emceed the event which also included presentations on the following work:

  • an America Makes project on an open-architecture multi-laser research platform for acceleration of large-scale additive manufacturing featuring Michael Tucker, Ph.D., GE Research, and Abdalla Nassar, Ph.D., Penn State University
  • ongoing efforts in additive manufacturing materials and process control at the National Center for Advanced Materials Performance by Chris Holshouser, Wichita State University’s National Institute for Aviation Research
  • an America Makes project on accelerating maturation of advanced manufacturing for low-cost sustainment (MAMLS) direct part production: effect of defects in laser powder bed fusion AlSi10Mg, featuring Holly Martin, Ph.D., Youngstown State University
  • future capability needs in additive manufacturing by Mark Benedict, Ph.D., Air Force Research Laboratory

For more information about AMSC, visit www.ansi.org/amsc. For more information about America Makes, visit www.americamakes.us.

CONTACT

Jana Zabinski

Director, Communications and Public Relations

Phone:
212.642.8901

Email:
jzabinski@ansi.org

Beth Goodbaum

Journalist/Communications Specialist

Phone:
212.642.4956

Email:
bgoodbaum@ansi.org

Share